Kia Rio: Thermostat: Removal - Cooling System - Engine Mechanical System - Kia Rio UB 2012-2026 Service ManualKia Rio: Thermostat: Removal


     
Disassembly of the thermostat would have an adverse effect, causing a lowering of cooling efficiency.
1.
Drain engine coolant so that its level would be under the thermostat height.
2.
Remove the radiator lower hose.
3.
Remove the water inlet fitting (A) and thermostat (B).


Thermostat: Components
1. Water inlet fitting 2. Thermostat 3. Heater pipe 4. Water temp control assembly 5. Water temperature sensor 6. Gasket ...

Inspection
1. Immerse the thermostat in water and gradually heat the water. 2. Check the valve opening temperature. Valv ...

See also:

Operation Condition for the ISG function
1. Auto stop or Auto start condition (If all of the below condition are satisfied) Items State Remark Driving conditions ISG OFF Switch ...

Waveform
This example shows a typical Crankshaft Position Sensor(CkPS) and Camshaft Position Sensor(CMPS) waveform at idle.The PCM controls the injection and ignition timing by using these sig ...

Tire Wear
   • Using tires and wheel other than the recommended sizes could cause unusual handling ...

Copyright www.kirmanual.com 2014-2026