Kia Rio: Transaxle Oil Temperature Sensor Removal - Automatic Transaxle Control System - Automatic Transaxle System - Kia Rio UB 2012-2025 Service ManualKia Rio: Transaxle Oil Temperature Sensor Removal

1.
Remove the battery and the battery tray.
(Refer to "Charging system" in EE group.)
2.
Remove the under cover (A).

Tightening torque:
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft) )


3.
Replace new gasket and the plug after draining the automatic transaxle fluid by removing the drain plug. (Refer to "Hydraulic system (Fluid)" in this group)
4.
Remove the air breather hose (A).
5.
Remove the valve body cover (B).

Tightening torque:
13.7 ~ 15.7 N.m (1.4 ~ 1.6 kgf.m, 10.8 ~ 11.6 lb-ft)


6.
Disconnect the oil temperature sensor connector (A).


7.
Remove the oil temperature sensor (A) after removing a bolt.

Tightening torque:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)


Transaxle Oil Temperature Sensor Inspection
1. Turn ignition switch OFF. 2. Disconnect the solenoid valve connector. 3. Measure resistance between sensor ...

Transaxle Oil Temperature Sensor Installation
1. Installation is the reverse of removal.    After replacement or reinstallation procedure of ...

See also:

5Door Projected Dimensions
Front side member tooling hole (Ø6.6) Front side member tooling hole (Ø6.6) Side cover mounting hol ...

Instrument panel overview
1. Instrument cluster 2. Horn 3. Driver’s front air bag 4. Light control/Turn signals 5. Wiper/Washer 6. Ignition switch or ENGINE START/ STOP button 7. Hazard warning flasher switch 8. Audio ...

Transmitter Inspection
1. Check that the red light flickers when the door lock or unlock button is pressed on the transmitter. 2. Remove the battery and check vol ...

Copyright © www.kirmanual.com 2014-2025