Kia Rio: Valve Body Installation
|
1. |
Installation is the reverse of removal.
|
|
After replacement or reinstallation procedure of the valve body
assembly, must perform procedures below.
|
| •
|
The gasket of the valve body gasket (A) use new one.
|
| •
|
Adding automatic transaxle fluid.
(Refer to "Hydraulic system (Fluid)" in this group)
|
| •
|
Perform TCM learning after replacing the valve body to
prevent slow transaxle response, jerky acceleration and jerky
startup. (Refer to "Automatic transaxle control system (Repair
procedures)" in this group)
|
|
1.
Remove the battery and the battery tray.
(Refer to "Charging system" in EE group.)
2.
Remove the under cover (A).
...
The 6-spd automatic transaxle consists of an overdrive clutch (OD/C),
a one-way clutch (OWC), a lower and reverse brake (LR/B), an underdrive brake
(UD/B), a 26 brake (26/B), and a 35R clutch ...
See also:
Cruise Control Switch: Removal
1.
Disconnect the battery (-) terminal.
2.
Remove the air-bag module from the steering wheel. (Refer to Restraint
- "Driver Airbag (DA ...
Starter: Specification
Starter [Non-ISG type]
Item
Specification
Rated voltage
12 V, 0.9 kW
The number of pinion teeth
10
Performance
[No-load, 1 ...
Power brakes
Your vehicle has power-assisted brakes that adjust automatically through normal
usage.
In the event that the power-assisted brakes lose power because of a stalled engine
or some other reason, you ...
Valve Body Removal
Clutch & Brake