Kia Rio: Accelerator Pedal Removal
| 1. |
Turn the ignition switch OFF and disconnect the negative (-) battery
cable.
|
| 2. |
Disconnect the accelerator position sensor connector (A).
|
| 3. |
Remove the installation nuts (B), and then remove the accelerator
pedal module.
|
Filler-Neck Assembly Installation
1.
Installation is reverse of removal.
Filler-neck assembly bracket
installation nut :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 ...
Accelerator Pedal Installation
1.
Installation is reverse of removal.
Accelerator pedal module installation
nut:
12.7 ~ 15.7 N.m (1.3 ~ 1.6 kgf.m, 9.4 ~ 11.6 lb- ...
See also:
Removal
1.
Disconnect the brake fluid level switch connector, and remove
the reservoir cap.
2.
Remove the brake fluid from the master cylinder res ...
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the VIS valve connector.
3.
Measure resistance between VIS valve ...
Components Location
1. Purge control solenoid valve (PCSV)
2. Vapor line
3. ORVR valve
4. Fuel tank air filter
5. Canister close valve (CCV)
6. Canister
7. Fuel tank pressure sensor ( ...
Copyright © www.kirmanual.com 2014-2024