ETC module learning procedure |
1. |
Hold the ignition key or the start button at the IG ON position
during 5 seconds.
|
2. |
Turn ignition swich OFF and then start the engine.
|
DTC codes (P0638, P2110) might be displayed if ETC module learning
procedure does not performed after replacing ETC module.
|
Thermostat: Components
1. Water inlet fitting
2. Thermostat
3. Heater pipe
4. Water temp control assembly
5. Water temperature sensor
6. Gasket
...
Sub Frame Replacement
1.
Remove the front wheel & tire.
Tightening torque :
88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
...
Rear Washer Motor Inspection
1.
With the washer motor connected to the reservoir tank, fill the
reservoir tank with water.
2.
Remove the front bumper cover. (Refer to t ...