1. |
Remove ignition key from the vehicle.
|
2. |
Disconnect the negative (-) cable from battery and wait for at
least thirty seconds.
|
3. |
Install the anchor pretensioner with a bolt.
|
4. |
Connect the anchor pretensioner connector.
|
5. |
Install the center pillar trim.
(Refer to the Body group - "Interior trim")
|
6. |
Install the door scuff trim.
(Refer to the Body group - "Interior trim")
|
7. |
Insert the seat belt to the anchor pretensioner (A).
|
8. |
Reconnect the battery negative cable.
|
9. |
After installing the anchor pretensioner, confirm proper system
operation:
|
Front Stabilizer Bar Replacement
1.
Remove the front wheel & tire.
Tightening torque :
88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
...
Schematic Diagram
Canister
The Canister is filled with charcoal and absorbs evaporated fuel vapor
from the fuel tank. The gathered fuel vapor in canister is drawn into the intake
manifold by the ECM/PC ...
Inhibitor Switch Removal
1.
Place the shift lever into the "N" position.
2.
Remove the air cleaner assembly.
(1)
Remove t ...