1. |
Disconnect the battery negative cable, and wait for at least thirty
seconds before beginning work.
|
2. |
Remove the seat belt after pushing the lock pin (A).
|
3. |
Remove the door scuff trim.
(Refer to the Body group - "Interior trim")
|
4. |
Remove the center pillar trim.
(Refer to the Body group - "Interior trim")
|
5. |
Disconnect the anchor pretensioner connector (A).
|
6. |
Loosen the anchor pretensioner mounting bolt (B) and remove the
anchor pretensioner.
|
Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector.
3.
Measure resistance between sensor ...
Engine Oil: Inspection
1.
Check the engine oil quality.
Check the oil deterioration, entry of water, discoloring of thinning.
If the quality is visibly poor, replace the oil.
...
Engine coolant
The high-pressure cooling system has a reservoir filled with year-round antifreeze
coolant. The reservoir is filled at the factory.
Check the antifreeze protection and coolant level at least once a ...