Kia Rio: Audio Remote Control Inspection

1.

Check the audio remote control switch (A) for resistance between No.5 and No.7 terminals in each switch position.

Switch	Connector terminal	Resistance (± 5%)
SEEK UP	6-7 (LH)	430 Ω
SEEK DOWN	6-7 (LH)	1.11 kΩ
MODE	6-7 (LH)	2.11 kΩ
MUTE	6-7 (LH)	3.11 kΩ
VOLUME UP	6-7 (LH)	4.61 kΩ
VOLUME DOWN	6-7 (LH)	6.81 kΩ
CANCEL	3-4 (RH)	180 Ω
SET -	3-4 (RH)	330 Ω
RES +	3-4 (RH)	550 Ω
ON/ OFF	3-4 (RH)	880 Ω
SLD	3-4 (RH)	1.44 kΩ
VOICE	3-4 (RH)	10.71 kΩ

Switch	Connector terminal	Resistance (± 5%)
END	5-6 (Lower LH)	18.91 kΩ
SEND	5-6 (Lower LH)	40.91 kΩ
TRIP	5-6 (Lower RH)	2.54 kΩ
RESET	5-6 (Lower RH)	5.54 kΩ

Audio Remote Control Schematic Diagrams

Circuit Diagram (1) Circuit Diagram (2) ...

Audio Remote Control Removal

1. Disconnect the negative (-) battery terminal. 2. Remove the driver airbag module. (Refer to the RT group - "DAB and Clock spring ...

See also:

Description
Automatic transaxle system relies on various measurement data to determine the current control status and extrapolate the necessary compensation values. These values are used to control the a ...

Compression Pressure Inspection
If there is lack of power, excessive oil consumption or poor fuel economy, measure the compression pressure. ...

Inspection
Cylinder Head 1. Inspect for flatness. Using a precision straight edge and feeler gauge, measure the surface the contacting the cylinder block and the manifolds ...

Categories

Copyright © www.kirmanual.com 2014-2024