|
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Using a screwdriver or trim remover, remove the center fascia
panel (A).
|
3. |
Disconnect the start/stop button connector (A) and hazard switch
connector (B).
|
4. |
After loosening the mounting screws, then remove the audio assembly
(A).
|
5. |
Disconnect the audio connector and cable (A).
|
Oil Pump Unit (OPU) Connector
Opu Connector Terminal Function
EGGG114-A
EGGG114-B
Pin No.
Description
Pin No.
Description
1
Motor power(W)
...
Muffler: Removal and Installation
1.
Disconnect the battery negative terminal.
Tightening torque
Without battery sensor :
7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ ...
SS-A Solenoid Valve(ON/OFF) Installation
1.
Installation is the reverse of removal.
•
When installing, ...