Kia Rio: Auto Light Sensor Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the photo & auto light sensor (A) from crash pad upper
side by using screw (-) driver.
|
| 3. |
Remove the auto light connector.
|
Auto Light Sensor Inspection
In the state of IGN1 ON, when multi function switch module detects auto
light switch on, tail lamp relay output and head lamp low relay output are controlled
according to auto light sensor ...
Auto Light Sensor Installation
1.
Reconnect the auto light connector.
2.
Install the auto light sensor.
...
See also:
Alternator: Removal and installation
1.
Disconnect the battery negative terminal first, then the positive
terminal.
Tightening torque
(+) terminal :
7 ...
SS-A Solenoid Valve(ON/OFF) Installation
1.
Installation is the reverse of removal.
•
When installing, ...
35R Clutch Control Solenoid Valve(35R/C_VFS) Description
35R clutch control solenoid valve(35R/C_VFS) is attached to the valve
body. This variable force solenoid valve directly controls the hydraulic pressure
inside the 35R clutch.
...
Copyright © www.kirmanual.com 2014-2024