Kia Rio: Blower Motor Replacement
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the crash pad and heater & blower unit assembly.
(Refer to HA group – “Heater Unit”)
|
| 3. |
Disconnect the blower motor connector (A).
|
| 4. |
Remove the blower motor (A) after loosening the screws.
|
| 5. |
Install in the reverse order of removal.
|
Blower Motor Inspection
1.
Connect the battery voltage and check the blower motor rotation.
2.
If the blower motor does not operate well, substitute with a know ...
Blower Resistor (MANUAL) Inspection
1.
Measure the resistance between the terminals.
2.
The measured resistance is not within specification, the blower
resistor must be replac ...
See also:
High Pressure Fuel Pump Installation
•
Be sure to check the low pressure fuel hose quick-connector
(A) is completely connecte ...
Inspection
Horn Inspection
Test the horn by connecting battery voltage to the 2 terminal and ground
the 1 terminal.
1 : 12V Ground(-)
2 : 12V (+)
...
Electrical System
1.
Be sure to disconnect the battery cable from the negative (-)
terminal of the battery.
2.
Never pull on the wires when disconnecting con ...
Copyright © www.kirmanual.com 2014-2024