Kia Rio: Blower Resistor (MANUAL) Inspection
| 1. |
Measure the resistance between the terminals.
|
| 2. |
The measured resistance is not within specification, the blower
resistor must be replaced. (After removing the resistor)
|
Blower Motor Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad and heater & blower unit assembly.
(Refer to HA group – “He ...
Blower Resistor (MANUAL) Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Disconnect the connector (A) and then remove the blower resistor
(B) after loosening th ...
See also:
Torque Converter Control Solenoid Valve (T/CON_VFS) Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector.
3.
Measure resistance between sensor ...
Components
1. Battery (Non-ISG Type)
2. Battery (ISG Type)
3. Battery tray
4. Battery insulation pad
5. Battery mounting bracket
...
Inspection
Rear Brake Disc Thickness Check
1.
Check the brake pads for wear and fade.
2.
Check the brake disc for damage and cracks.
...
Copyright © www.kirmanual.com 2014-2024