Kia Rio: Blower Resistor (MANUAL) Replacement
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Disconnect the connector (A) and then remove the blower resistor
(B) after loosening the mounting screws.
|
| 3. |
Install in the reverse order of removal.
|
Blower Resistor (MANUAL) Inspection
1.
Measure the resistance between the terminals.
2.
The measured resistance is not within specification, the blower
resistor must be replac ...
Power Mosfet (FATC) Inspection
1.
Turn the ignition switch ON.
2.
Manually operate the control switch and measure the voltage of
blower motor.
3.
...
See also:
Removal
1.
Remove the fuel pump.
(Refer to Engine Control/Fuel System - “Fuel Pump”)
2.
Remove the ORVR valve (A) after releasing hooks (B).
...
AVN Head Unit Installation
AVN Head Unit
1.
Connect the AVN head unit connectors and cable.
2.
Install the AVN head unit.
3.
Install t ...
Removal
1.
Disconnect the battery negative (-) cable.
2.
Disconnect the battery sensor connector.
3.
Remove the battery ...
Copyright © www.kirmanual.com 2014-2024