1. |
Check installation status of BBVPS and Vacuum hose or damage of
vacuum hose.
|
2. |
Connect GDS to DLC (Data Link Cable).
|
3. |
Warm up the engine to normal operating temperature.
|
4. |
Monitor "BBVPS" parameter on GDS.
Fig.1) Idle Status
Fig.2) Brake pressure signal
|
Coolant: Refilling And Bleeding
Never remove the radiator cap when the engine is hot. Serious
scalding could be caused by hot fluid under high pressure ...
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to the BD group - "Crash pad")
...
Inhibitor Switch Removal
1.
Place the shift lever into the "N" position.
2.
Remove the air cleaner assembly.
(1)
Remove t ...