1. |
Remove the RH front tire.
(Refer to SS group - “Front Tire”)
|
2. |
Remove the engine room RH side under cover.
(Refer to EM group - “Engine and Transaxle Assembly”)
|
3. |
Separate the front portion of the front wheel guard (A) from the
wheel house.
|
4. |
Loosen the drive belt.
(Refer to EM group - “Timing Chain”)
|
5. |
Remove the center bolt (A) and the hub bolts (B) while holding
the pulley with a disc & hub assembly bolt remover (09977-25100).
|
6. |
Remove the hub assembly (A) and shim (gap washer) (B), taking
care not to lose the shim.
|
7. |
Remove the pulley (B) after removing the snap ring (A) with snap
ring pliers.
|
8. |
Reassembly is the reverse order of disassembly.
|
Oil Pump Components
1. Oil pump cover
2. Oil pump housing
3. Driven gear
4. Drive gear
5. Oil seal
6. Bushing-housing
7. Reaction shaft
8. Bushing-reaction shaft
9. Sleeve
10 ...
Specification
[Throttle Position Sensor (TPS)]
Throttle angle(°)
Output Voltage (V)
TPS1
TPS2
0
0.5
4.5
10
0.96
4.05
...
Brake Switch Installation
1.
Install is reverse of removal.
...