Kia Rio: Compressor Removal
| 1. |
If the compressor is marginally operable, run the engine at idle
speed, and let the air conditioning work for a few minutes, then shut
the engine off.
|
| 2. |
Disconnect the negative cable from the battery.
|
| 3. |
Recover the refrigerant with a recovery/charging station.
|
| 4. |
Remove the RH front tire.
(Refer to SS group - “Front Tire”)
|
| 5. |
Remove the engine room RH side under cover.
(Refer to EM group - “Engine and Transaxle Assembly”)
|
| 6. |
Separate the front portion of the front wheel guard (A) from the
wheel house.
|
| 7. |
Loosen the drive belt.
(Refer to EM group - “Timing Chain”)
|
| 8. |
Disconnect the suction line (A) and discharge line (B) from the
compressor.
|
| 9. |
Disconnect the compressor switch connector (A).
|
| 10. |
Remove the compressor by loosening the mounting bolts.
|
Compressor Components
1. Center Bolt
2. Hub Bolt
3. Hub Assembly
4. Snap Ring
5. Pulley
6. Compressor Assembly
7. Electric Control Valve (ECV)
...
Compressor Installation
1.
Make sure of the length of compressor mounting bolts, and then
tighten it with the specified tightening order.
Tightening torque :
...
See also:
Defroster
CAUTION - Conductors
To prevent damage to the conductors bonded to the inside surface of the rear
window, never use sharp instruments or window cleaners containing abrasives to clean
the window. ...
Components
1. Master cylinder
2. Ignition lock switch
3. Clutch switch
4. Pedal pad
...
Copyright © www.kirmanual.com 2014-2024