Kia Rio: Delivery Pipe Removal
In case of removing the high pressure fuel pump, high pressure
fuel pipe, delivery pipe, and injector, there may be injury caused by
leakage of the high pressure fuel. Before repairing the high pressure
system, be sure to release the residual pressure in fuel line as step
2 in below procedure.
|
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Release the residual pressure in fuel line (Refer to the Fuel
Delivery System - Repair Procedures - "Release Residual Pressure in
Fuel Line").
|
| 3. |
Remove the intake manifold (Refer to "Intake And Exhaust System"
in EM group).
|
| 4. |
Disconnect the injector connectors (A) and the rail pressure sensor
connector (B).
|
| 5. |
Remove the high pressure fuel pipe (C).
|
| 6. |
Remove the engine oil gauge.
|
| 7. |
Remove the installation bolt (D), and then remove the delivery
pipe and injector assembly from the engine.
|
Accelerator Pedal Installation
1.
Installation is reverse of removal.
Accelerator pedal module installation
nut:
12.7 ~ 15.7 N.m (1.3 ~ 1.6 kgf.m, 9.4 ~ 11.6 lb- ...
Delivery Pipe Installation
•
Do not use already used injector fixing clip again.
...
See also:
35R Clutch Control Solenoid Valve(35R/C_VFS) Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require
additional hydraulic pressure adjustment; however, the ...
ESC Control Module Installation
1.
Installation is the reverse of removal.
2.
Tighten the HECU mounting bolts and nuts to the specified torque.
3.
...
Rain Sensor Removal
The rain sensor may not operate properly if contaminated. Protect
the rain sensor surface by not removing the cover unti ...
Copyright © www.kirmanual.com 2014-2024