Kia Rio: Description
Back view camera will activate when the backup light is ON with the ignition
switch ON and the shift lever in the R position.
This system is a supplemental system that shows behind the vehicle through
the ECM (Reverse Display Room Mirror) mirror or AVN head unit while backing-up.
This system is a supplementary function only. It is the responsibility
of the driver or always check the inside/ outside rearview mirror and
the area behind the vehicle before and while backing up because there
is a dead zone that can't see through the camera.
|
Circuit Diagram
...
Removal
1.
Remove the trunk trim in the trunk after removing the screws and
clips.
(Refer to the BD group - "Tailgate")
2.
Remove ...
See also:
Removal
1.
Disconnect the brake fluid level switch connector, and remove
the reservoir cap.
2.
Remove the brake fluid from the master cylinder res ...
Inhibitor Switch Specifications
▷ Type: Combination of output signals from 4 terminals
Power supply (V)
12
Output type
Combination of output signals
Signal Code Table
...
Specification
Item
Specification
Coil resistance (Ω)
30.0 ~ 35.0 [20°C(68°F)]
...
Copyright © www.kirmanual.com 2014-2024