Kia Rio: Dimensions Projected - General Information - Kia Rio UB 2012-2024 Service ManualKia Rio: Dimensions Projected

1.
These are the dimensions measured when the measurement points are projected from the vehicle's surface, and are the reference dimensions used for used for body alterations.
2.
If the length of the tracking gauge probes is adjustable, measure it by lengthening one of two probes as long as the different value in height of the two surface.


Measuring Body Dimensions
1. Basically, all measurements in this manual are taken with a tracking gauge. 2. When a measuring tape is used, check to be sure there is ...

Measuring Actual Dimensions
1. These dimensions indicate the actual linear distance between measurement points, and are used as the reference dimensions when a tracking gauge is used for measurem ...

See also:

Hands free switch Inspection
1. Check the hands free remote control switch for resistance between No.4 and No.5 terminals in each switch position. Audio + Bluetooth [LH] ...

Specification
HO2S [Bank 1/Sensor 1] Item Specification Heater Resistance (Ω) 2.4 ~ 4.0 [20°C(68°F)] HO2S [Bank 1/Sensor 2] A/F Ratio (λ) ...

Front Wiper Motor Installation
1. Install the wiper motor. 2. Install the crank arm. 3. Install the lower and upper linkage to the wiper motor ...

Copyright © www.kirmanual.com 2014-2024