1. |
Disconnect the negative (-) battery terminal.
|
2. |
Disconnect the evaporator temperature sensor connector (A).
|
3. |
Remove the evaporator temperature sensor (A) by pulling it out
after rotating 90° in a counterclockwise direction.
|
4. |
Install in the reverse order of removal.
|
Wipers & Washers
A : Wiper speed control (front)
HI – High wiper speed
LO – Low wiper speed
INT – Intermittent wipe
AUTO– Automatic control wipe
OFF – Off
MIST – Single wipe
B : Intermittent control ...
Rain Sensor System Function
Basic Principle
Emitted Beam from luminosity diode is reflected entirely against the windshield
exterior, and then turn into photo diode.
If there is water on the windshield exterior, be ...
Removal
Engine removal is not required for this procedure.
•
Use fender covers to avoid damaging pa ...