1. |
Turn the ignition switch OFF.
|
2. |
Disconnect the foot connector.
|
3. |
Verify that the foot actuator operates to the open position when
connecting 12V to the terminal 3 and grounding terminal 4.
Verify that the foot actuator operates to the close position when
connecting in the reverse.
|
4. |
Connect the foot actuator connector.
|
5. |
Turn the ignition switch ON.
|
6. |
Check the voltage between terminals 6 and 5.
Specification
With auto defogging activated
With auto defogging deactivated
It will feedback current position of actuator to controls.
|
7. |
If the measured voltage is not within specification, substitute
with a known-good foot actuator and check for proper operation.
|
8. |
Replace the foot actuator if it is proved that there is a problem
with it.
|
Installation
•
Install the component with the specified torques.
•
...
Audio Unit Schematic Diagrams
System Block Diagram
...
Rear Hub - Carrier Inspection
1.
Check the hub for cracks and the splines for wear.
2.
Check the brake disc for scoring and damage.
3.
C ...