1. |
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
|
2. |
Remove the front wheel and tire (A) from front hub.
|
3. |
Remove the brake caliper mounting bolts, and then hold the brake
caliper assembly (B) with wire.
|
4. |
Remove the brake hose bracket (A) & wheel speed sensor (B).
|
5. |
Remove driveshaft nut (A) from the front hub after applying the
brake.
|
6. |
Remove the tie rod end ball joint from the knuckle by using the
SST(09568-34000).
|
7. |
Remove the lower arm (A) from the knuckle.
|
8. |
Disconnect the driveshaft (A) from the front hub assembly.
|
9. |
Insert a pry bar (A) between the transaxle case and joint case,
and separate the drive shaft (B) from the transaxle case.
|
10. |
Install in the reverse order of removal.
|
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the RPS at idle and various engine
speed.
...
Heater Unit Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Recover the refrigerant with a recovery/recycling/charging station.
3.
...
Inhibitor Switch Description
Inhibitor Switch monitors the lever's position(PRND) and is used to control
gear setting signals.
...