1. |
Disconnect the negative(-) battery terminal.
|
2. |
Remove the lighting switch of the multi-function switch. (Refer
to the multifunction switch)
|
3. |
With the front fog lamp switch, make sure that continuity exists
between the terminals below.
If continuity is not as specified, replace the multi-function
switch.
|
Temperature Control Actuator Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the temperature control actuator connector.
3.
Verify that the t ...
Specification
[Throttle Position Sensor (TPS)]
Throttle angle(°)
Output Voltage (V)
TPS1
TPS2
0
0.5
4.5
10
0.96
4.05
...
Warning / Caution Label Locations
1. Fan caution
2. Radiator cap caution
3. Battery caution
...