1. |
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
|
2. |
Remove the front wheel and tire (A) from front hub .
|
3. |
Remove the brake caliper mounting bolts , and then hold the brake
caliper assembly (B) with wire.
|
4. |
Remove the brake hose mounting bracket (A) & wheel speed sensor
(B) & bracket (C).
|
5. |
Remove driveshaft nut (A) from the front hub under applying the
brake.
|
6. |
Remove the tie rod end ball joint from the knuckle.
|
7. |
Remove the lower arm (A) from the knuckle.
|
8. |
Disconnect the driveshaft (A) from the front hub assembly.
|
9. |
Loosen the strut mounting bolts and then remove the knuckle assembly
(A).
|
10. |
Install in the reverse order of removal.
|
Inspection
Front Brake Disc Thickness Check
1.
Check the brake pads for wear and fade.
2.
Check the brake disc for damage and cracks.
...
Rear Wheel Alignment
When using a commercially available computerized wheel alignment
equipment to inspect the rear wheel alignment, always p ...
Mode Control Actuator Description
The mode control actuator is located at the heater unit.
It adjusts position of mode door by operating mode control actuator based
on signal of A/C control unit. Pressing mode select switch ...