The support rod must be inserted into the hole near the edge of
the hood whenever you inspect the engine compartment to prevent the
hood from falling and causing possible injury.
Make sure that the support rod has been released prior to closing
the hood. Always check to be sure the hood is firmly latched before
driving the vehicle.
|
Lift And Support Points
When heavy rear components such as suspension, fuel tank, spare
tire, tailgate and trunk lid are to be removed, pla ...
Wipers & Washers
A : Wiper speed control (front)
HI – High wiper speed
LO – Low wiper speed
INT – Intermittent wipe
AUTO– Automatic control wipe
OFF – Off
MIST – Single wipe
B : Intermittent control ...
Adjustment
ETC module learning procedure
When installing new ETC module or re-installing it, ETC module learning
procedure must be performed.
1.
Hold the ignition key o ...