Kia Rio: Hazard Lamp Switch Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Using a screwdriver or trim remover, remove the hazard lamp switch
(A).
|
| 3. |
Disconnect the hazard lamp switch connector.
|
License Lamp Installation
1.
Install the bulb.
2.
Connect the lens and license lamp.
...
Hazard Lamp Switch Installation
1.
Connect the connectors.
2.
Install the hazard lamp switch.
3.
Connect the negative (-) battery terminal.
...
See also:
Description
The charging system included a battery, an alternator with a built-in
regulator, and the charging indicator light and wire.
The Alternator has eight built-in diodes, each rectifying AC curre ...
TPMS Sensor Description
1.
Mode
(1)
Normal Fixed Base State
A.
Sensor transmissions continue at the Low Line
...
AGM Battery: Adjustment
Battery charging
In general, vehicle battery charging system has three forms.
1.
Constant current charge: The battery voltage gradually rises by
chargi ...
Copyright © www.kirmanual.com 2014-2024