Kia Rio: Heater Unit Components
| 1. Shower Duct (Left) 2. Heater Pipe Cover 3. Mode Control Actuator 4. Mode Control Actuator Bracket 5. Defog mode lever (FATC) 6. Mode Control Main Lever (MANUAL) 7. Vent Sub lever 8. Vent Door Lever |
9. Foot Sub Lever 10. Heat Case (Left) 11. Heater Core Assembly 12. Aspirator Hose 13.Temperature Control Actuator 14. Temperature Control Actuator Lever 15. Temperature Door Lever |
| 1. NVH Pad 2. Defog Seal 3. Vent Seal 4. Vent/Defog Door 5. Foot Door 6. Temperature Door 7. Evaporator Temperature Sensor Hole Cover 8. Evaporator Temperature Sensor 9. Heater Lower Case 10. Drain Hose |
11. Heater Case (Right) 12. Blower Resistor (MANUAL) 13. Power Mosfet (FATC) 14. Foot Actuator (With auto defogging system) 15. Cool Box Hose 16. Shower Duct (Left) 17. Flange Seal 18. Evaporator Flange Clip 19. Evaporator Core Cover 20. Evaporator Core |
Heater Unit Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Recover the refrigerant with a recovery/recycling/charging station.
3.
...
See also:
Fuel Pump Inspection
[Fuel pump]
1.
Turn ignition switch OFF and disconnect the negative (-)battery
cable.
2.
Remove the fuel pump assembly.
...
Input Speed Sensor Signal Waveform
Fig 1) Input/Output speed sensor at low speed
Fig 2) Input/Output speed sensor at high speed ...
Rear Bumper Replacement
[5 Door]
•
Put on gloves to protect your hands.
•
...
Copyright © www.kirmanual.com 2014-2024