Kia Rio: Ignition Switch Assembly Inspection
| 1. |
Disconnect the ignition switch connector (B) and key switch connector
(A) from under the steering column.
|
| 2. |
Check for continuity between the terminals.
|
| 3. |
If continuity is not specified, replace the switch.
|
Start/Stop Button Installation
1.
Install the start/stop button.
2.
Install the Audio.
...
Ignition Switch Assembly Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering column upper and lower shrouds.
(Refer to the ST group - & ...
See also:
TPMS Receiver Description
1.
Mode
(1)
Virgin State
A.
The receiver as a sole part is shipped in this
state. ...
Description
The Evaporative Emission Control System prevents fuel vapor stored in
fuel tank from vaporizing into the atmosphere. When the fuel evaporates in the
fuel tank, the vapor passes through vent h ...
Rain Sensor System Function
Basic Principle
Emitted Beam from luminosity diode is reflected entirely against the windshield
exterior, and then turn into photo diode.
If there is water on the windshield exterior, be ...
Copyright © www.kirmanual.com 2014-2024