1. |
Check that the shift lever is placed in the "N" position
|
2. |
Install the inhibitor switch (A).
|
3. |
Install the manual control lever (A).
|
4. |
Align the hole (A) in the manual control lever with the "N" position
hole (B) of the inhibitor switch and then insert the SST inhibitor switch
guide pin (09480-A3800).
|
5. |
Tighten the nut (A) and bolts (B) with the specified torque.
|
6. |
Remove the SST (09480-A3800) from the hole.
|
7. |
Connect the inhibitor switch connector (A).
|
8. |
Install the shift cable by tightening nut (B).
|
9. |
Push the shift cable to the arrow "F" to eliminate free play and
then tighten the nut (A) with the specified torque.
|
10. |
Install the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
|
11. |
Install the air cleaner assembly.
(Refer to Engine Mechanical System - "Air cleaner")
|
Tailgate
Opening the tailgate
Type A
The tailgate is locked or unlocked by turning the key to the "Lock" or "Unlock"
position.
If unlocked, the tailgate can be opened by pressin ...
Component
1. Remote control assembly
2. Airbag module
3. Wiring
4. Heated steering control unit
5. Steering wheel body
6. Lower cover
...
Blower Resistor (MANUAL) Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Disconnect the connector (A) and then remove the blower resistor
(B) after loosening th ...