Kia Rio Manuals

Kia Rio: Inspection - Battery Sensor - Charging System - Engine Electrical System - Kia Rio UB 2012-2024 Service ManualKia Rio: Inspection

1.
Check for DTCs.

     
•
If a DTC is present, perform troubleshooting in accordance with the procedure for that DTC. (Refer to DTC guide)
2.
Check if battery sensor status is normal on current data by using GDS.
If its value is ON, replace the battery sensor.
A.
Invalid Conditon of Battery sensor (AMS) = OFF



     
•
Battery sensor may operate abnormally if the parasitic current is more than 100mA.
Therefore, if battery sensor signal error occurs, inspect the vehicle parasitic current first before replacing the battery sensor.
(Refer to Charging System - "Battery")
Installation
1. Install in the reverse order of removal. Battery sensor cable installation bolt: 10.8 ~ 13.7 N.m (1.1 ~ 1.4 kgf.m, 8.0 ~10.1 lb-ft) ...

Adjustment
Battery Sensor Recalibration Procedure If disconnecting the negative (-) battery cable from the battery during repair work for the vehicle equipped with Alternator Managing Syst ...

See also:

Description
Knocking is a phenomenon characterized by undesirable vibration and noise and can cause engine damage. Knock Sensor (KS) is installed on the cylinder block and senses engine knocking. Whe ...

Intake Actuator Replacement
1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad. (Refer to BD group - "Crash Pad") ...

Back-up Lamp Switch Replacement
1. Disconnect the back up lamp switch connector (A). 2. Remove the back up lamp switch (A). 3. ...

Categories


Copyright © www.kirmanual.com 2014-2024