1. |
Disconnect the vapor hose from the intake manifold and connect
a vacuum pump to the nipple on the intake manifold.
· At Cold Engine [Engine Coolant Temperature < 60°C(140°F)]
|
2. |
Check the following points with applied vacuum at the purge control
solenoid valve (PCSV).
· At Warmed Engine [Engine Coolant Temperature > 80°C(176°F)]
|
1. |
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
|
2. |
Disconnect the PCSV connector (A).
|
3. |
Disconnect the vapor hose (B) which is connected to the intake
manifold from the PCSV.
|
4. |
After connecting a vacuum pump to the nipple, apply vacuum.
|
5. |
With the PCSV control line grounded, check the valve operation
with battery voltage applied to the PCSV(Open) and removed(Closed).
|
6. |
Measure the coil resistance of the PCSV.
|
1. |
Select "Evap. Leakage Test".
|
2. |
Proceed with the test according to the screen introductions.
|
Component Location
1. Sunroof
2. Sunroof switch
3. Sunroof motor & controller
...
DC/DC Converter: Circuit Diagram
In the ISG mode, if the power of an audio system turnsOFF by drawdown
while “Auto Starting” or “Idle Starting”functi ...
Fuses
A vehicle’s electrical system is protected from electrical overload damage by
fuses.
This vehicle has 2 fuse panels, one located in the driver’s side panel bolster,
the other in the engine comp ...