Kia Rio: Inspection
Throttle Position Sensor (TPS)
| 1. |
Connect the GDS on the Data Link Connector (DLC).
|
| 2. |
Start the engine and measure the output voltage of TPS 1 and 2
at C.T. and W.O.T.
|
ETC Motor
| 1. |
Turn the ignition switch OFF.
|
| 2. |
Disconnect the ETC module connector.
|
| 3. |
Measure resistance between the ETC module terminals 1 and 2.
|
| 4. |
Check that the resistance is within the specification.
|
Circuit Diagram
(M/T)
(A/T)
...
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Remove the resonator and the air intake hose (Refer to “I ...
See also:
Seat Belt Switch Removal
1.
Remove the front seat.
2.
After loosening the mounting bolt, then remove the front seat
belt buckle (A).
...
Inspection
1.
Check the brake tubes for cracks, crimps and corrosion.
2.
Check the brake hoses for cracks, damage and fluid leakage.
3 ...
Alternator: Specification
Items
Specification
ISG Alternator
Rated voltage
13.5V, 110A
Speed in use
1,000 ~ 18,000rpm
Voltage regulator
...
Copyright © www.kirmanual.com 2014-2024