1. |
Turn the ignition switch OFF.
|
2. |
Disconnect the IATS connector.
|
3. |
Measure resistance between the IATS terminals 3 and 4.
|
4. |
Check that the resistance is within the specification.
|
Manual Transaxle Installation
When replacing a clutch housing or transaxle assembly, the wiring
bracket should be installed in accordance with the clu ...
Inspection
1.
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification:
Refer to “Wave Form”
...
Trunk Lid Adjustment
1.
After loosening the trunk lid hinge (A) mounting bolt, adjust
the trunk lid by moving it up or down, or right or left.
2.
Adjust the tru ...