1. |
Inspect diaphragm spring wear which is in contact with a concentric
slave cylinder bearing.
|
2. |
Check the clutch cover and disc surface for wear or cracks.
|
3. |
Check the clutch disc lining for slipping or oil marks.
|
4. |
Measure the depth from a clutch lining surface to a rivet. If
the measured value is less than the specification below, replace it.
|
SRS Control Module (SRSCM) Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three
minutes before beginning ...
Sunroof Components
1 . Glass panel assembly
2 . Glass panel
3 . Reinforcement glass
4 . Encapsulated glass panel
5 . Wind deflector net assembly
6 . Wind deflector beam
7 . Plate cover [RH] ...
5Door Projected Dimensions
Front side member tooling hole (Ø6.6)
Front side member tooling hole (Ø6.6)
Side cover mounting hol ...