1. |
Measure the clutch pedal height (from the face of the pedal pad
to the floorboard) and the clutch pedal clevis pin play (measured at
the face of the pedal pad.)
|
1. |
Disconnect 2P-connector from a ignition lock switch.
|
2. |
Disconnect the ignition lock switch. (if you can install a tester
with the switch fixed, this step can be omissible)
|
3. |
Check for continuity between terminals. (refer to the table below)
|
4. |
If there is difference between what tested and the table above,
replace the ignition lock switch with a new one.
|
Starter: Cleaning
1.
Do not immerse parts in cleaning solvent. Immersing the yoke assembly
and/or armature will damage the insulation. Wipe these parts with a
cloth only.
...
Front Hub / Knuckle Inspection
1.
Check the hub for cracks and the splines for wear.
2.
Check the brake disc for scoring and damage.
3.
C ...
How to use this manual
We want to help you get the greatest possible driving pleasure from your vehicle.
Your Owner’s Manual can assist you in many ways.We strongly recommend that you read
the entire manual. In order to ...