Kia Rio: Installation
Installation is in the reverse order of removal.
Perform the following :
| • |
Adjust a shift cable.
|
| • |
Refill engine with engine oil.
|
| • |
Refill a transaxle with fluid.
|
| • |
Refill power steering fluid.
|
| • |
Refill a radiator and a reservoir tank with engine coolant.
|
| • |
Clean battery posts and cable terminals and assemble.
|
| • |
Inspect for fuel leakage.
|
| - |
After assemble the fuel line, turn on the ignition switch (do
not operate the starter) so that the fuel pump runs for approximately
two seconds and fuel line pressurizes.
|
| - |
Repeat this operation two or three times, then check for fuel
leakage at any point in the fuel line.
|
| • |
Bleed air from the cooling system.
|
| - |
Start engine and let it run until it warms up. (until the radiator
fan operates 3 or 4 times.)
|
| - |
Turn Off the engine. Check the level in the radiator, add coolant
if needed. This will allow trapped air to be removed from the cooling
system.
|
| - |
Put radiator cap on tightly, then run the engine again and check
for leaks.
|
Removal
•
Use fender covers to avoid damaging painted surfaces.
•
...
Timing System
...
See also:
Components
1. HECU module
2. Front wheel speed sensor
3. Rear wheel speed sensor
4. Yaw rate & G sensor
5. Steering angle sensor
6. ABS Warning lamp
7. Parking brake/EBD warn ...
Specifications
Items
Specification
Hood
Type
Rear hinged, front opening type
Front Door
Construction
Front hinged, full door construction
...
Trunk Lid Replacement
Trunk Lid Assembly Replacement
•
When removing and installing the trunk lid, an assistant
...
Copyright © www.kirmanual.com 2014-2024