Kia Rio: Installation
| 1. |
Install in the reverse order of removal.
|
| 2. |
Adjust the alternator belt tension after installation.
(Refer to Engine charging System - "Drive belt tension measurement
and adjustment")
|
Removal
1.
Disconnect the battery negative terminal.
2.
Disconnect the air compressor connector (A) and the alternator
connector (B), and remove th ...
Disassembly
1.
Remove the rear cover (A) after removing nuts.
2.
Remove the mounting bolts (A) and the brush holder assembly (B).
...
See also:
Front Impact Sensor (FIS) Installation
•
Do not turn the ignition switch ON and do not contact
the battery cable while replacin ...
Components
1. Master cylinder
2. Ignition lock switch
3. Clutch switch
4. Pedal pad
...
Auto Light Sensor Inspection
In the state of IGN1 ON, when multi function switch module detects auto
light switch on, tail lamp relay output and head lamp low relay output are controlled
according to auto light sensor ...
Copyright © www.kirmanual.com 2014-2024