Kia Rio Manuals

Kia Rio: Installation - Engine Control Module (ECM) - Engine Control System - Engine Control / Fuel System - Kia Rio UB 2012-2024 Service ManualKia Rio: Installation


     
When replacing the ECM, the vehicle equipped with immobilizer must be performed the procedure as below.
[In the case of installing used ECM]
1.
Perform "Neutral mode" procedure with GDS. (Refer to "Immobilizer" in BE group)
2.
Insert the key and turn it to the IGN ON and OFF position.
Then the ECM key register process is completed automatically.
[In the case of installing new ECM]
-
Insert the key and turn it to the IGN ON and OFF position.
Then the ECM key register process is completed automatically.
1.
Installation is reverse of removal.
ECM installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
ECM bracket installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
Removal
   When replacing the ECM, the vehicle equipped with immobilizer must be performed the procedure as below. ...

ECM Problem Inspection Procedure
1. TEST ECM GROUND CIRCUIT: Measure resistance between ECM and chassis ground using the backside of ECM harness connector as ECM side check point. If the problem is fo ...

See also:

Manual transaxle
Manual transaxle operation The manual transaxle has 6 forward gears. This shift pattern is imprinted on the shift knob. The transaxle is fully synchronized in all forward gears so shifting to ei ...

Power Out Side Mirror Switch Component
...

Brake Switch Inspection
1. Connect a circuit tester to the connector of stop lamp switch, and check whether or not there is continuity when the plunger of the stop lamp switch is pushed in an ...

Categories


Copyright © www.kirmanual.com 2014-2024