1. |
Replace a clutch cover and disc as a set.
|
2. |
Apply grease on a disc spline part and transmission input shaft
spline part as required.
|
3. |
The 'T/M SIDE' marked surface should face the transmission.
|
4. |
Install the clutch disc and the cover with SST(A : 09411-1P000).
|
5. |
Install the clutch cover bolts. Not to be bent or twisted, Tighten
them in diagonal directions.
|
6. |
Install the transaxle assembly.
(Refer to "Manual transaxle system" in MT group.)
|
Components
1. Cylinder head cover
2. Cylinder head cover gasket
3. Cylinder head assembly
4. Cylinder head gasket
5. Camshaft position sensor
6. Camshaft bearing cap
7. Camshaft ...
AGM Battery: Inspection
Battery Diagnostic Flow
Vehicle parasitic current inspection
1.
Turn all the electric devices OFF, and then turn the ignition
switch OFF.
...
Cruise Control Switch: Installation
1.
Install in the reverse order of removal.
...