Kia Rio: Installation
|
1. |
Installation is the reverse of removal.
|
|
If the oil seal on the transaxle case side is damaged and fluid
is leaking, replace the oil seal with a new unit. When installing the
new oil seal, use the specialized tool (oil seal installer, 09452-26100).
|
|
After replacement or reinstallation procedure of the automatic
transaxle assembly, must perform procedures below.
| •
|
Power steering fluid replacement and air bleeding. (Refer
to "General information" in ST group)
|
| •
|
Adding automatic transaxle fluid. (Refer to "Hydraulic
system (Fluid)" in this group)
|
| •
|
After servicing the automatic transaxle or TCM, clear
the diagnostic trouble codes (DTC) using the GDS tool.
Diagnostic trouble codes (DTC) cannot be cleared by disconnecting
the battery.
|
| •
|
When deleting diagnostic trouble code, use the GDS as
possible.
|
| •
|
When replacing the automatic transaxle, reset the automatic
transaxle's values by using the GDS.
|
| •
|
Perform TCM learning after replacing the transaxle to
prevent slow transaxle response, jerky acceleration and jerky
startup. (Refer to "Automatic transaxle control system (Repair
procedures)" in this group)
|
|
1.
Remove the following items;
A.
Air cleaner assembly (A) and air duct (B).
(Refer to "Intake and Exhaust system" ...
See also:
Fail-Safe Mode
Item
Fail-Safe
ETC Motor
Throttle valve stuck at 7°
TPS
TPS 1 fault
ECM looks at TPS2
TPS 2 fault
ECM looks at TPS1 ...
Transaxle Control Module (TCM) Description
Transaxle Control Module (TCM) is the automatic transaxle's brain. The
module receives and processes signals from various sensors and implements a
wide range of transaxle controls to ensu ...
Warnings and indicators
All warning lights are checked by turning the ignition switch ON (do not start
the engine). Any light that does not illuminate should be checked by an authorized
Kia dealer.
After starting the en ...
Removal
Hydraulic System