1. |
Remove the ignition key from the vehicle.
|
2. |
Disconnect the battery negative cable and wait for at least thirty
seconds.
|
3. |
Install the seat belt pretensioner with bolts (B, C).
|
4. |
Connect the seat belt pretensioner connector (A).
|
5. |
Install the upper anchor bolt.
|
6. |
Install the center pillar trim.
(Refer to the Body group - "Interior trim")
|
7. |
Install the door scuff trim.
(Refer to the Body group - "Interior trim")
|
8. |
Insert the seat belt to the anchor pretensioner.
|
9. |
Reconnect the battery negative cable.
|
10. |
After installing the seat belt pretensioner, confirm proper system
operation:
|
Smart key unit Removal
Smart key unit
[USA]
1.
Disconnect the negative(-) battery terminal.
2.
Remove the smart key unit (A) after disconnecting the c ...
SRS Control Module (SRSCM) Variant coding
After replacing the SRSCM with a new unit, the “Variant Coding” procedure
must be performed.
1.
...
Door Switch Inspection
1.
Remove the door switch and check for continuity between the terminals.
...