|
1. |
Apply sealant (C) between the wheel cylinder (B) and backing plate
(D), and install the wheel cylinder.
|
2. |
Connect the brake tubes (A) to the wheel cylinder.
|
3. |
Connect the parking brake cable (A) to the brake shoe.
|
4. |
Install the brake shoes (C) onto the backing plate. Be careful
not to damage the wheel cylinder dust covers.
|
5. |
Install the shoe hole down pins (B) and the shoe hole down springs
(A).
|
6. |
Clean the threaded portions of adjuster sleeve (A) and push rod
female (B). Coat the threads of the adjuster assembly with grease. To
shorten the clevises, turn the adjuster bolt (C).
|
7. |
Hook the shoe adjuster lever (C), then install it to the brake
shoe.
|
8. |
Install the adjuster assembly (B) and upper return spring (A)
as right direction. Be careful not to damage the wheel cylinder dust
covers.
|
9. |
Install the lower return spring (B).
|
10. |
Apply brake cylinder grease or equivalent rubber grease to the
sliding surfaces shown. Don't get grease on the brake linings.
|
11. |
Apply brake cylinder grease or equivalent rubber grease to the
brake shoe ends and opposite edges of the shoes shown. Don't get grease
on the brake linings.
|
12. |
Install the rear brake drum (A).
|
13. |
If the wheel cylinder has been removed, bleed the brake system.
|
14. |
Depress the brake pedal several times to set the self-adjusting
brake.
|
15. |
Adjust the parking brake.
|
Trouble Symptom Charts
Trouble Symptom 1
Trouble Symptom 2
Trouble symptom
Probable cause
Remedy
The set vehicle speed varies greatly upward or downward
"Surgin ...
Lubricants
Items
Specified lubricants
Quantity
Input shaft spline
CASMOLY L9508
0.2g
Clutch release cylinder assembly
Brake flu ...
Transaxle Control Module (TCM) connector and terminal function
...