Kia Rio: Installation
•
|
Install the component with the specified torques.
|
•
|
Note that internal damage may occur when the component
is dropped. If the component has been dropped, inspect before
installing.
|
|
•
|
Apply engine oil to the valve O-ring.
|
|
1. |
Installation is reverse of removal.
CVVT oil control valve installation
bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
|
|
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the CVVT oil control valve connector (A).
...
See also:
Temperature Control Actuator Description
The heater unit includes mode control actuator and temperature control
actuator.
The temperature control actuator is located at the heater unit. It regulates
the temperature by the proced ...
Tire pressure monitoring system
(1) Low tire pressure telltale / TPMS malfunction indicator
Each tire, including the spare (if provided), should be checked monthly when
cold and inflated to the inflation pressure recommended by ...
Rear Washer Motor Inspection
1.
With the washer motor connected to the reservoir tank, fill the
reservoir tank with water.
2.
Remove the front bumper cover. (Refer to t ...