Kia Rio: Instrument Cluster Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Using a screwdriver or romover, remove the cluster fascia panel
(A).
|
| 3. |
Disconnect the start/stop button connector (A) and hazard switch
connector (B).
|
| 4. |
Using a screwdriver or remover, remove the cluster fascia panel
(A).
|
| 5. |
Remove the cluster fascia (A) from the crash pad after removing
2 screws.
|
| 6. |
Disconnect the cluster fascia connecters (A) and then remove the
cluster.
|
Instrument Cluster Inspection
Speedometer
1.
Adjust the pressure of the tires to the specified level.
2.
Drive the vehicle onto a speedometer tester. Use wheel chocks
...
Instrument Cluster Installation
1.
Connect the cluster connector.
2.
Install the cluster assembly.
3.
Install the center fascia panel.
...
See also:
Front Stabilizer Bar Replacement
1.
Remove the front wheel & tire.
Tightening torque :
88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
...
Removal
1.
Remove the transaxle assembly.
(Refer to "Manual transaxle system" in MT group)
2.
Remove the clutch cover bolts. Be care ...
Front Wheel Speed Sensor Inspection
1.
Measure the output voltage between the terminal of the wheel speed
sensor and the body ground.
...
Copyright © www.kirmanual.com 2014-2024