1. |
Turn the ignition switch OFF.
|
2. |
Disconnect the intake actuator connector.
|
3. |
Verify that the intake actuator operates to the fresh position
when connecting 12V to terminal 4 and grounding terminal 3.
Verify that the intake actuator operates to the recirculation
position when connecting in the reverse.
|
4. |
Connect the intake actuator connector.
|
5. |
Turn the ignition switch ON.
|
6. |
Check the voltage between terminal 6 and 5.
Specification
|
7. |
If the intake actuator is not operated well, substitute with a
known-good intake actuator and check for proper operation.
|
8. |
Replace the intake actuator if it is proved that there is a problem
with it.
|
Hood Replacement
Hood Assembly Replacement
•
When removing and installing the hood, an assistant is
...
Fuel Pump Removal
1.
Release the residual pressure in fuel line (Refer to the Fuel
Delivery System - Repair Procedures - "Release Residual Pressure in
Fuel Line").
...
Output Speed Sensor Removal
1.
Remove the battery and the battery tray.
(Refer to "Charging system" in EE group.)
2.
Remove the under cover (A).
...