Kia Rio: Line Pressure Control Solenoid Valve Circuit Diagram

Line Pressure Control Solenoid Valve Specifications

Direct control VFS[LINE Pressure] ▷ Control type : Normal low type Control Pressure kpa (kgf/cm², psi) 500.14 ~ 9.81 (5.1 ~ 0.1,72.54 ~ 1.42) Current ...

Line Pressure Control Solenoid Valve Inspection

1. Turn ignition switch OFF. 2. Disconnect the solenoid valve connector. 3. Measure resistance between sensor ...

See also:

Console Replacement
Floor Console Replacement [M/T]    • A plastic trim tool is recommended, but if p ...

Air bag collision sensors
(1) SRS control module (2) Front impact sensor (3) Side impact sensor WARNING - Air bag sensors Do not hit or allow any objects to impact the locations where air bag or sensors are installed ...

Dynamic Damper Replacement
1. Remove the front driveshaft. (Refer to DS group - “Front Driveshaft”) 2. Remove the TJ joint assembly. (Refer to DS group - “TJ joint”) ...