1. |
Remove the following items;
|
2. |
Remove the following items;
|
3. |
Remove the ground cable bolt (A) and tube bracket bolt (B).
|
4. |
Remove the transaxle upper mounting bolt (B-2ea) and the start
motor mounting bolt (A-2ea).
|
5. |
Remove the cowl top cover.
(Refer to BD group.)
|
6. |
Using the engine support fixture (Support SST No.: 09200-2S200,
Adapter SST No.: 09200-1P000, 4X000, Beam SST No.: 09200-38001/3N000),
hold the engine and transaxle assembly safely.
|
7. |
Remove the mounting cover (A).
|
8. |
Remove the transaxle support mounting bracket bolts (A-2ea).
|
9. |
Remove the transaxle support mounting bracket bolts (A-3ea).
|
10. |
Lifting up the vehicle.
|
11. |
Remove the under cover (A).
|
12. |
Remove the clutch release cylinder assembly (A) by removing bolts
(B-2ea).
|
13. |
Remove the drive shaft assembly.
(Refer to "Drive shaft assembly" in DS group.)
|
14. |
Remove the drive shaft cover (A).
|
15. |
Remove the brackets (A).
|
16. |
Remove the roll rod bracket (C) after removing bolt (A,B).
|
17. |
Remove the mounting bolts (A-3ea, B-2ea) of lower part of the
transaxle, and the left side cover and remove the transaxle assembly
by supporting it with a jack.
|
Removal
1.
Disconnect the battery negative cable, and wait for at least thirty
seconds before beginning work.
2.
Remove the seat belt after pushin ...
Signal Waveform
...
Blower Unit Replacement
1.
Remove the heater & blower unit.
(Refer to HA group - "Heater Unit")
2.
Separate the blower unit from the heater unit a ...