Kia Rio: Measuring Actual Dimensions
| 1. |
These dimensions indicate the actual linear distance between measurement
points, and are used as the reference dimensions when a tracking gauge
is used for measurement.
|
| 2. |
First adjust both probes to the same length (A=A') before measurement.
|
Dimensions Projected
1.
These are the dimensions measured when the measurement points
are projected from the vehicle's surface, and are the reference dimensions
used for used for body ...
Measurement Point
Measurements should be taken at the center of the hole.
...
See also:
Specification
[Throttle Position Sensor (TPS)]
Throttle angle(°)
Output Voltage (V)
TPS1
TPS2
0
0.5
4.5
10
0.96
4.05
...
Components
1. Shoe hold down pin
2. Shoe adjuster
3. Upper return spring
4. Adjusting lever
5. Shoe
6. Adjusting spring
7. Lower return spring
8. Shoe hold spring
...
Tail Gate Adjustment
1.
After loosening the tail gate hinge (A) mounting bolt, adjust
the tail gate by moving it up or down, or right or left.
2.
Adjust the tai ...
Copyright © www.kirmanual.com 2014-2024