Kia Rio: Mode Control Actuator Replacement
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the crash pad.
(Refer to BD group - "Crash Pad")
|
| 3. |
Remove the BCM unit.
(Refer to BE group - "BCM")
|
| 4. |
Disconnect the connector (A) and then remove the mode control
actuator (B) after loosening the mounting screws.
|
| 5. |
Install in the reverse order of removal.
|
Mode Control Actuator Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the mode control actuator connector.
3.
Verify that the mode con ...
Foot Actuator (With Auto Defogging System) Description
The foot actuator is located at the heater unit. It adjusts position of
the foot door in heater unit of the vehicle equipped with the auto defogging
system. ...
See also:
Installation
•
Install the component with the specified torques.
•
...
Multimedia Jack Installation
1.
Install the multimedia jack.
2.
Connect the multimedia jack connector.
...
Dynamic Damper Components
1. BJ assembly
2. Circlip
3. BJ boot band
4. BJ boot
5. Dynamic damper band
6. Dynamic damper
7. Shaft
8. TJ boot band
9. TJ boot
10. Spider assembly
1 ...
Copyright © www.kirmanual.com 2014-2024