1. |
Remove the ignition key from the vehicle.
|
2. |
Disconnect the battery negative cable from battery and wait for
at least thirty seconds before beginning work.
|
3. |
Place the passenger airbag on the crash pad and tighten the passenger
airbag mounting bolts.
|
4. |
Install the heater duct to the crash pad.
|
5. |
Install the crash pad.
(Refer to the Body group- "Crash pad")
|
6. |
Tighten the passenger airbag crash pad mounting bolt.
|
7. |
Connect the passenger airbag harness connector to the SRS main
harness connector.
|
8. |
Reinstall the glove box.
(Refer to the Body group - "Crash pad")
|
9. |
Reconnect the battery negative cable.
|
10. |
After installing the passenger airbag (PAB), confirm proper system
operation:
|
Vehicle load limit
Tire and loading information label
The label located on the driver's door sill gives the original tire size, cold
tire pressures recommended for your vehicle, the number of people that can be ...
Seat Belt Buckle Switch (BS) Removal
1.
Disconnect the battery negative cable, and wait for at least three
minutes before beginning work.
2.
Remove the front seat assembly.
...
4Door Front Body C
Engine mounting hole (Ø11)
Transaxle mounting hole (Ø12)
Engine mounting hole (Ø12)
...